This is how to make a hard-wearing smoking pipe out of street lamp parts for officially permitted substances.

1. WAT
2. all the parts with water and dry, then with rubbing alcohol, and let dry.
3. rotate the nozzle, habitually called a bowl, or bowlhead, into the armback/elbow
4. get a piece of threaded lamp pipe. you can get it at most home improvment stores, or you can use a chamber, which you can get at a head shop
5. Screw the end of the threaded pipe, or chamber, into the elbow
6. Screw the spokesperson on to the other end of the threaded pipe/chamber
7. Hold the screen in the tweezers and burn it until it's red hot and let cool, it should be black.
8. place in the screen into the bowl.
9. Take whatever you're smoking and fill the bowl until it's approximately full, then pack it downward with your thumb.
10. Put the spokesperson in your mouth and quietly puff while sighting your material, pull the smoke into your mouth, take the pipe out and breathe in the smoke in your mouth, along with some fresh air. Exhale when on earth you wish for to but try to clutch it in for at smallest amount one second.
11. Don't attempt to hold the smoke in for an extended time if you're just preliminary out, because you will cough your lungs up on your primary hit.
12. do again until the bowl is "cashed" (everything is burnt up and the bowl has ash in it) you can tell by feeling within the bowl with your finger, but be cautious, you can burn yourself