The well-organized way to sketch tobacco and additional officially permitted smokes into your lungs. Also known as a bucket bong.

1. Take a artificial container (at least a 2 liter, gallon works well) and unfilled its contents.
2. Take a 3/8 drill bit and drill a hole in the middle of the plastic lid. Or for an additional realistic and easier time you can just take a lighter and slowly burn the top of the cap somewhat so it softens up, then push the metal socket into the melting plastic for an hermetically sealed seal.
3. Find a ceiling fan and remove a metal sphere positioned accurate at the base of the pull string. (Don't worry: your ceiling fan's presentation will not be exaggerated, plus you can reattach it when you're done). A more no-nonsense idea would be to use a socket from your garage (or a bowl from another water pipe).
4. Cut the bottom off of your synthetic urn leaving as much volume as probable, there's usually a loop near the bottom that's just above the 5 fingered base. It's an outstanding guide line.
5. Now, find a bucket great sufficient to fully submerge your urn and fill it with water. Full gallon jugs are the just right size, too.
6. Place the urn into the water with the cap uninvolved, and the pinnacle of the container an inch or two above the exterior of the water.
7. Load your ceiling fan accessory with your preferred smoking substance and insecurely turn on your lid (be sure to put the urn into the water 1st previous to screwing on your lid or as well it may eject your material).
8. Now begin lighting the material while concurrently elating your urn out of the water (this suction from the water and container unscrambling simulates picture smoke into your lungs (the smoke should be thick, the color of egg nog).
9. Once the urn is nearly full and previous to the bottom comes out of the water, get ready yourself...
10. Twist off the cap and place your mouth on top of the container and inhale.